1
2
3
4
5
6
1
1. plotting
- In this phase, the perimeter of the single piece that will compose the finished duct (linear or fitting) after cutting and assembling is plotted on the panel.
2
2. cutting
- Using the appropriate tools (manual or automatic) in this phase, the single pieces to be used in the fabrication of the duct are cut from the panel.
3
3. bending
- In this phase (required only for the production of duct fittings), indentations are applied to the piece of panel allowing the panel to be adapted to the shapes of the finished duct.
4
4. gluing
- During gluing, all pieces produced above are assembled with the use of special glues and the finished duct takes shape.
5
5. closing
- In this phase, the duct is trimmed and finished through pressing and taping.
 |
|
 |
|
 |
|
6
6. accessories application
- Using specific tools and glues, the section bars required are applied to the finished duct. When the duct is installed, these section bars permit easy connection of the single pieces for the completion of the air distribution system.